Changes to Step #7
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Disassembly |
|---|---|
| + | [* 1] 1. Cut the zip ties holding the extruder assembly to the linear bearings. |
| + | [* 1] 2. Remove the timing belt. Replace if worn or damaged. |
| + | [* 1] 3. Carefully pull the wires through the x-end assembly |
| + | [* 1] 4. Tear down the entire extruder by reversing the assembly instructions provided by Prusa. |
| + | [* 1] 5. All the printed parts will be replaced. Most of the electrical parts and fasteners will be reused. |
| + | [* 1] 6. Check all wires and connectors for possible damage |
| + | [* 1] 7. Check the PFTE tubes for possible damage. |