Changes to Step #7

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Disassembly
[* 1] 1. Cut the zip ties holding the extruder assembly to the linear bearings.
[* 1] 2. Remove the timing belt. Replace if worn or damaged.
[* 1] 3. Carefully pull the wires through the x-end assembly
[* 1] 4. Tear down the entire extruder by reversing the assembly instructions provided by Prusa.
[* 1] 5. All the printed parts will be replaced. Most of the electrical parts and fasteners can be reused.
[* 1] 6. Check all wires and connectors for possible damage especially where wires had made a tight bend or may have been clamped too tightly.
-[* 1] 7. Check the PFTE tubes for possible damage.
+[* 1] 7. If you already have the PFTE tube at the correct length, check it for possible damage.