Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Check your new printed parts |
|---|---|
| + | [* 1] Take the time to check your printed parts: |
| + | [* 1] Clean up strings with tweezers and hot air gun (be careful). |
| + | [* 1] Carefully check inside holes of X ends smooth rods. |
| + | [* 1] Remove possible elephant foot with a deburring tool. |
| + | [* 1] Check all bridges. If a bridge is falling in its center: heat tweezers with a lighter and press on the bad looking zone to make it more flat. |