Changes to Step #4
Edit by Dave Ogles —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Check your new printed parts | |
| [* 1] Take the time to check your newly printed parts: | |
| - | [* 1] Clean up strings with tweezers and hot air gun (be careful). |
| + | [* 1] Clean up strings with tweezers and a hot air gun (be careful). |
| [* 1] Carefully check inside the holes of the X ends, where the smooth rods will be inserted. | |
| [* 1] Remove any elephant foot with a deburring tool. | |
| [* 1] Check all bridges. If a bridge is falling in its center: heat tweezers with a lighter(or use a soldering iron) and press on the area with the poor bridging, to make it more flat. | |
| [* 1] Make sure the filament path through the extruder body is clean, round, and clear from obstructions. |