Checking Firmware Safety Step #4 History

Changes to Step #4

Edit by 3D_Gussner — Oct 16, 2019

	[title] Min Temp Error for Hotend (2/2)
	[* 2] After few seconds you should get the *Err: MINTEMP* error message displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
-	[* 1] Quickly plug back the *hotend thermistor* and let the hotend cool down under 50°C.
+	[* 1] Quickly plug back the *hotend thermistor* and let the hotend cool down *under 50°C*.
	[* 5] Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is *above* 50°C can cause heat creep!
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.

	[title] Min Temp Error for Hotend (2/2)
	[* 2] After few seconds you should get the *Err: MINTEMP* error message displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
-	[* 1] Quickly plug back the *hotend thermistor* and let the hotend cool down under 50°C.
+	[* 1] Quickly plug back the *hotend thermistor* and let the hotend cool down *under 50°C*.
	[* 5] Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is *above* 50°C can cause heat creep!
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.