Changes to Step #4

Edit by 3D_Gussner —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Min Temp Error for Hotend (2/2)
[* 2] After few seconds you should get the ***Err: MINTEMP*** error message displayed on the printer.
-[* 6] Set targeted temperatures back to ***0°C*** via "Preheat/Cooldown" or "Settings/Temperature" menus.
+[* 6] Set targeted temperatures back to ***0°C*** via ''Preheat/Cooldown'' or ''Settings/Temperature'' menus.
[* 1] Quickly plug back the hotend thermistor and let the hotend cool down under 50°C.
[* 1] Turn the printer off after Hotend and Bed are cooled down to room temperature.
[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.