Changes to Step #6
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Min Temp Error for Bed (2/2) |
|---|---|
| + | [* 2] After few seconds (it is a bit longer for the bed) you must have the ***err MINTEMP BED*** error message displayed on the printer. |
| + | [* 6] The targeted temperatures should be set to ***0°C***. |
| + | [* 1] Quickly plug back the bed thermistor. |
| + | [* 1] Let the hotend cool down under 50°C. |
| + | [* 1] Turn the printer off. |
| + | [* 9] If this behave differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help. |
Image 1
No previous image
Added