Checking Firmware Safety Step #6 History

Changes to Step #6

Edit by 3D_Gussner — Oct 16, 2019

	[title] Min Temp Error for Heated Bed (2/2)
	[* 2] After few seconds (it is a bit longer for the bed) you must have the *Err: MINTEMP BED* error message displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
	[* 1] Quickly plug back the *heated bed thermistor* and let the hotend cool down to at lease *50°C*.
-	[* 1] Turn the printer off.
+	[* 1] Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is *above* 50°C can cause heat creep!
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.

	[title] Min Temp Error for Heated Bed (2/2)
	[* 2] After few seconds (it is a bit longer for the bed) you must have the *Err: MINTEMP BED* error message displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
	[* 1] Quickly plug back the *heated bed thermistor* and let the hotend cool down to at lease *50°C*.
-	[* 1] Turn the printer off.
+	[* 1] Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is *above* 50°C can cause heat creep!
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.