Changes to Step #7

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preparing a cable to test thermal runaway
-[* 10] To test runaway protection (or MAX TEMP protection) you need to shortcut the thermistor pins. The best way is to build a little jumper connector.
-[* 1] Rambo Einsy and Mini are both using 2 pins Molex 50-57-9402 connector (with Molex 16-02-0097 pins).
-[* 1] Alternatively you can cut an old thermistor and connect both wires together.
+[* 10] To test runaway protection (or MAXTEMP protection) you need to shortcut the thermistor pins on the Rambo board.
+[* 1] You will need a Female to Female Dupon cable to shortcut the thermistor connector.
+[* 1] Alternatively you can cut an old thermistor and connect both wires together (those that are connected on the connector side).