Changes to Step #7

Edit by 3D_Gussner —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preparing a cable to test thermal runaway
[* 10] To test runaway protection (or MAXTEMP protection) you need to shortcut the thermistor pins on the Rambo board.
-[* 1] You will need a Female to Female Dupon cable to shortcut the thermistor connector.
-[* 1] Alternatively you can cut an old thermistor and connect both wires together (those that are connected on the connector side).
+[* 8] You will need a Female to Female Dupon cable to shortcut the thermistor connector.
+[* 8] Alternatively you can cut an old thermistor and connect both wires together (those that are connected on the connector side).