Changes to Step #8

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Thermal Runaway Error for Hotend (1/2)
[* 1] Turn the printer off.
[* 1] Unplug the ***hotend thermistor*** wires:
[* 3] Rambo Mini hotend thermistor connector (MK2, MK2S, MK2.5 and MK2.5S).
[* 5] Rambo Einsy hotend thermistor connector (MK3 and MK3S).
-[* 1] Plug both side of your Dupon cable into the ***hotend thermistor connector*** on the controller board.
+[* 1] Plug both ends of the Dupon cable into the ***hotend thermistor connector*** on the controller board. This will shortcut the connector.