Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Thermal Runaway Error for Hotend (2/2) |
|---|---|
| + | [* 1] Plug both side of you Dupon cable into the hotend thermistor connector on the Rambo. |
| + | [* 1] The printer must instantly emit noisy bip. |
| + | [* 2] The ***Err: MAXTEMP*** error message must be displayed on the printer. |
| + | [* 5] The hotend temperature must be set to a very high value. |
| + | [* 1] Quickly plug back the hotend thermistor and let the hotend cool down under 50°C. |
| + | [* 1] Turn off the printer and reconnect the hotend thermistor. |
| + | [* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help. |
Image 1
No previous image
Added