Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Thermal Runaway Error for Hotend (2/2) | |
| - | [* black] Plug both side of your Dupon cable into the ***hotend thermistor connector*** on the controller board. |
| - | [* black] Turn the printer on. |
| [* black] The printer must instantly emit noisy bip just after having started. | |
| [* red] The ***Err: MAXTEMP*** error message should be displayed on the printer. | |
| [* light_blue] The displayed hotend temperature should show a very high value. (See example picture: ***739***/0°) | |
| [* black] Unplug the Dupon test cable and plug back the ***hotend thermistor***. Make sure that the displayed hotend temperature is back to a normal value. | |
| [* black] Turn off the printer. | |
| [* icon_caution] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help. |