Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Runaway |
|---|---|
| + | [title] Thermal Runaway Error for Hotend (2/2) |
| [* 1] Plug both side of you Dupon cable into the hotend thermistor connector on the Rambo. | |
| [* 1] The printer must instantly emit noisy bip. | |
| [* 2] The ***err MAXTEMP*** error message must be displayed on the printer. | |
| [* 5] The hotend temperatures must be set to a very high value. | |
| [* 1] Turn off the printer and reconnect the hotend thermistor. | |
| [* 9] If this behave differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help. |