Changes to Step #9

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Thermal Runaway Error for Hotend (2/2)
[* 1] Plug both side of you Dupon cable into the hotend thermistor connector on the Rambo.
[* 1] The printer must instantly emit noisy bip.
[* 2] The ***Err: MAXTEMP*** error message must be displayed on the printer.
[* 5] The hotend temperature must be set to a very high value.
[* 1] Turn off the printer and reconnect the hotend thermistor.
-[* 9] If this behave differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.
+[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.