Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Thermal Runaway Error for Hotend (2/2) | |
| [* black] Plug both side of you Dupon cable into the hotend thermistor connector on the Rambo. | |
| [* black] The printer must instantly emit noisy bip. | |
| [* red] The ***Err: MAXTEMP*** error message must be displayed on the printer. | |
| [* green] The hotend temperature must be set to a very high value. | |
| + | [* black] Quickly plug back the hotend thermistor and let the hotend cool down under 50°C. |
| [* black] Turn off the printer and reconnect the hotend thermistor. | |
| [* icon_caution] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help. |