Changes to Step #11

Edit by 3D_Gussner —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 1] Plug both sides of you Dupon cable into the ***heated bed thermistor connector*** on the controller board.
[* 2] The ***Err: MAXTEMP BED*** error message must be displayed on the printer.
[* 6] The displayed heated bed temperature should show a very high value. (See example picture: ***368***/0°)
-[* 1] Quickly plug back the heated bed thermistor and let the hotend cool down under 50°C.
-[* 1] Turn off the printer and reconnect the hotend thermistor.
+[* 1] Unplug the Dupon test cable and plug back the ***heated bed thermistor***.Make sure that the displayed bed temperature is back to a normal value.
+[* 1] Turn off the printer.
[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.