Checking Firmware Safety Step #11 History

Changes to Step #11

Edit by 3D_Gussner — Oct 16, 2019

+	[title] Thermal Runaway Error for Heated Bed (2/2)
	[* black] Plug both sides of you Dupon cable into the *heated bed thermistor connector* on the controller board.
	[* red] The *Err: MAXTEMP BED* error message must be displayed on the printer.
	[* light_blue] The displayed heated bed temperature should show a very high value. (See example picture: *368*/0°)
	[* black] Unplug the Dupon test cable and plug back the *heated bed thermistor*.Make sure that the displayed bed temperature is back to a normal value.
	[* black] Turn off the printer.
	[* icon_caution] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.

+	[title] Thermal Runaway Error for Heated Bed (2/2)
	[* black] Plug both sides of you Dupon cable into the *heated bed thermistor connector* on the controller board.
	[* red] The *Err: MAXTEMP BED* error message must be displayed on the printer.
	[* light_blue] The displayed heated bed temperature should show a very high value. (See example picture: *368*/0°)
	[* black] Unplug the Dupon test cable and plug back the *heated bed thermistor*.Make sure that the displayed bed temperature is back to a normal value.
	[* black] Turn off the printer.
	[* icon_caution] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.