Checking Firmware Safety Step #11 History

Changes to Step #11

Edit by 3D_Gussner — Oct 16, 2019

	[title] Thermal Runaway Error for Heated Bed (2/2)
	[* 1] Plug both sides of you Dupon cable into the *heated bed thermistor connector* on the controller board.
	[* 2] The *Err: MAXTEMP BED* error message must be displayed on the printer.
-	[* 6] The displayed heated bed temperature should show a very high value. (See example picture: *368*/0°)
+	[* 3] The displayed heated bed temperature should show a very high value. (See example picture: *368*/0°)
	[* 1] Unplug the Dupon test cable and plug back the *heated bed thermistor*.Make sure that the displayed bed temperature is back to a normal value.
	[* 1] Turn off the printer.
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.

	[title] Thermal Runaway Error for Heated Bed (2/2)
	[* 1] Plug both sides of you Dupon cable into the *heated bed thermistor connector* on the controller board.
	[* 2] The *Err: MAXTEMP BED* error message must be displayed on the printer.
-	[* 6] The displayed heated bed temperature should show a very high value. (See example picture: *368*/0°)
+	[* 3] The displayed heated bed temperature should show a very high value. (See example picture: *368*/0°)
	[* 1] Unplug the Dupon test cable and plug back the *heated bed thermistor*.Make sure that the displayed bed temperature is back to a normal value.
	[* 1] Turn off the printer.
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.