Changes to Step #11
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [* black] Plug both side of you Dupon cable into the heated bed thermistor connector on the Rambo. | |
| [* red] The ***Err: MAXTEMP BED*** error message must be displayed on the printer. | |
| [* light_blue] The heated bed temperature must be set to a very high value. | |
| + | [* black] Quickly plug back the heated bed thermistor and let the hotend cool down under 50°C. |
| [* black] Turn off the printer and reconnect the hotend thermistor. | |
| [* icon_caution] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help. |