Skip to main content

Changes to Step #12

Edit by Grégoire Saunier

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preheat Error for Hotend (1/2)
[* black] Turn the printer off and then on.
[* black] Locate the hotend heater connector on your controller board:
[* orange] Rambo Mini hotend heater connector (MK2, MK2S, MK2.5 and MK2.5S).
[* green] Rambo Einsy hotend heater connector (MK3 and MK3S).
-[* yellow] Preheat the heated bed and extruder for PLA temperature through the ''Preheat'' menu of your printer. You also can set just the temperature of the nozzle to 215°C in the ''Settings/Temperature'' menu.
+[* yellow] Preheat the heated bed and extruder for PLA temperature through the ''Preheat'' menu of your printer.