Changes to Step #12

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preheat Error for Hotend (1/2)
[* 1] Turn the printer off and then on.
[* 1] Locate the hotend heater connector on your Rambo board:
[* 3] Rambo Mini hotend heater connector (MK2, MK2S, MK2.5 and MK2.5S).
[* 5] Rambo Einsy hotend heater connector (MK3 and MK3S).
-[* 4] Preheat the heated bed and extruder for PLA temperature through the ''preheat'' menu of your printer.
+[* 4] Preheat the heated bed and extruder for PLA temperature through the ''Preheat'' menu of your printer.