Checking Firmware Safety Step #13 History

Changes to Step #13

Edit by 3D_Gussner — Oct 16, 2019

	[title] Preheat Error for Hotend (2/2)
	[* 1] Once the hotend temperature is higherthan 80°C, unplug the *hotend heater* from the Rambo board.
	[* 2] After few minutes and you should get the *PREHEAT ERROR* message displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
	[* 1] Plug back the *hotend thermistor* and let the hotend cool down under 50°C.
-	[* 1] Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is *above* 50°C can cause heat creep!
+	[* 5] Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is *above* 50°C can cause heat creep!
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.

	[title] Preheat Error for Hotend (2/2)
	[* 1] Once the hotend temperature is higherthan 80°C, unplug the *hotend heater* from the Rambo board.
	[* 2] After few minutes and you should get the *PREHEAT ERROR* message displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
	[* 1] Plug back the *hotend thermistor* and let the hotend cool down under 50°C.
-	[* 1] Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is *above* 50°C can cause heat creep!
+	[* 5] Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is *above* 50°C can cause heat creep!
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.