Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #13

Edit by Grégoire Saunier

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preheat Error for Hotend (2/2)
-[* black] Once the hotend temperature is higher than 80°C, unplug the ***hotend heater*** from the Rambo board.
[* red] After few minutes and you should get the ***PREHEAT ERROR*** message displayed on the printer.
[* light_blue] Set targeted temperatures back to ***0°C*** via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
[* black] Plug back the ***hotend heater*** and let the hotend cool down ***under 50°C***.
[* black] Turn the printer off after hotend and heated bed are cooled down.
[* icon_caution] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.