Changes to Step #13
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Preheat Error for Hotend (2/2) | |
| [* black] Once the hotend temperature is bigger than 80°C, unplug the hotend heater from the Rambo board. | |
| [* red] After few minutes and you must have the ***PREHEAT ERROR*** message displayed. | |
| [* light_blue] The targeted temperatures must be set to ***0°C***. | |
| [* black] Plug back the hotend heater. | |
| [* black] Turn the printer off. | |
| + | [* icon_caution] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help. |