Changes to Step #14

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preheat Error for Heated Bed (1/2)
[* 1] Turn the printer off.
[* 1] Locate the heated bed heater connector on your controller board:
[* 3] Rambo Mini heated bed heater connector (MK2, MK2S, MK2.5 and MK2.5S).
[* 5] Rambo Einsy heated bed heater connector (MK3 and MK3S).
[* 1] Unplug the ***heated bed heater*** from the controller board.
+[* 1] Turn the printer on.
+[* 4] Preheat the heated bed and extruder for PLA temperature through the ''Preheat'' menu of your printer.