Checking Firmware Safety Step #15 History

Changes to Step #15

Edit by Grégoire Saunier — Oct 16, 2019

	[title] Preheat Error for Heated Bed (2/2)
	[* 1] Once the heated bed temperature is higher than 40°C, unplug the *heated bed heater* from the controller board.
	[* 2] After few minutes and you should get the *BED THERMAL RUNAWAY* message displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
	[* 1] Plug back the bed heater and let the hotend cool down *under 50°C*.
-	[* 1] Turn the printer off after ~~Hotend~~ and ~~Bed~~ are cooled down. ~~Turning off the printer while the Hotend is *above* 50°C can cause heat creep!~~
+	[* 1] Turn the printer off after hotend and heated bed are cooled down.
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.

	[title] Preheat Error for Heated Bed (2/2)
	[* 1] Once the heated bed temperature is higher than 40°C, unplug the *heated bed heater* from the controller board.
	[* 2] After few minutes and you should get the *BED THERMAL RUNAWAY* message displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
	[* 1] Plug back the bed heater and let the hotend cool down *under 50°C*.
-	[* 1] Turn the printer off after ~~Hotend~~ and ~~Bed~~ are cooled down. ~~Turning off the printer while the Hotend is *above* 50°C can cause heat creep!~~
+	[* 1] Turn the printer off after hotend and heated bed are cooled down.
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.