Changes to Step #15
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Preheat Error for Heated Bed (2/2) | |
| - | [* black] Once the heated bed temperature is higher than 40°C, unplug the ***heated bed heater*** from the controller board. |
| - | [* red] After few minutes you should get the ***BED THERMAL RUNAWAY*** message displayed on the printer. |
| + | [* black] Turn the printer on. |
| + | [* black] Preheat the heated bed and extruder for PLA temperature through the ''Preheat'' menu of your printer. |
| + | [* red] After around 2 minutes you should get the ***BED THERMAL RUNAWAY*** message displayed on the printer. |
| [* light_blue] Set targeted temperatures back to ***0°C*** via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu. | |
| [* black] Plug back the bed heater and let the hotend cool down ***under 50°C***. | |
| [* black] Turn the printer off after hotend and heated bed are cooled down. | |
| [* icon_caution] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help. |