Checking Firmware Safety Step #15 History

Changes to Step #15

Edit by Grégoire Saunier — May 19, 2020

	[title] Preheat Error for Heated Bed (2/2)
-	[* 2] After around 2 minutes you should get the *BED THERMAL RUNAWAY* message displayed on the printer.
+	[* 2] After around 2 minutes you should get the *BED PREHEAT ERROR* message on firmware 3.9.0 and upper or *BED THERMAL RUNAWAY* message on firmware lower than 3.9.0 displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
	[* 1] Plug back the bed heater and let the hotend cool down *under 50°C*.
	[* 1] Turn the printer off after hotend and heated bed are cooled down.
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.

	[title] Preheat Error for Heated Bed (2/2)
-	[* 2] After around 2 minutes you should get the *BED THERMAL RUNAWAY* message displayed on the printer.
+	[* 2] After around 2 minutes you should get the *BED PREHEAT ERROR* message on firmware 3.9.0 and upper or *BED THERMAL RUNAWAY* message on firmware lower than 3.9.0 displayed on the printer.
	[* 6] Set targeted temperatures back to *0°C* via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
	[* 1] Plug back the bed heater and let the hotend cool down *under 50°C*.
	[* 1] Turn the printer off after hotend and heated bed are cooled down.
	[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.