Changes to Step #17

Edit by 3D_Gussner —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Hotend Fan (2/2)
-[* 4] Preheat the hotend to 80°C through the _settings -> temperature_ menu of your printer.
+[* 4] Preheat the hotend to 80°C through the ''Settings/Temperature'' menu of your printer.
[* 1] Once the hotend temperature reach 80°C, unplug the hotend fan connector.
-[* 2] After few seconds you must have the ***Err: EXTR. FAN ERROR*** error message displayed.
-[* 6] The targeted temperatures must be set to ***0°C***.
-[* 1] Quickly plug back the hotend thermistor and let the hotend cool down under 50°C.
-[* 1] Turn the printer off.
+[* 2] After few seconds you should get the ***Err: EXTR. FAN ERROR*** error message displayed on the printer.
+[* 6] Set targeted temperatures back to ***0°C*** via ''Preheat/Cooldown'' or ''Settings/Temperature'' menu.
+[* 1] Quickly plug back the ***hotend fan*** and let the hotend cool down under 50°C.
+[* 5] Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is ***above*** 50°C can cause heat creep!
[* 9] If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.