Changes to Step #2
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Preparation |
|---|---|
| + | [* 1] Unload the filament present in your hotend. |
| + | [* 1] Move the extruder higher than the Rambo Cover. |
| + | [* 1] Open the Rambo cover lid. |
| + | [* 1] If at some point you are unsure about wiring check careful the Prusa manual pages. |
| + | [* 10] The Rambo board images in this guide are coming from the Prusa manual pages: https://manual.prusa3d.com |