Changes to Step #2
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Preparation | |
| [* 1] Unload the filament from your hotend. | |
| [* 1] Move the extruder higher than the controller cover. | |
| [* 1] Open the controller cover lid. | |
| + | [* 1] Unplug USB connector (for Octoprint for example). |
| [* 1] If at some point you are unsure about wiring check carefully the Prusa manual pages. | |
| [* 10] The controller board images in this guide are coming from the Prusa manual pages: https://manual.prusa3d.com |