Changes to Step #2

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preparation
[* 1] Unload the filament from your hotend.
-[* 1] Move the extruder higher than the controller cover.
-[* 1] Open the controller cover lid.
+[* 1] Move the extruder higher than the Rambo cover.
+[* 1] Open the Rambo cover lid.
[* 1] Unplug USB connector (for Octoprint for example).
[* 1] If at some point you are unsure about wiring check carefully the Prusa manual pages.
[* 10] The controller board images in this guide are coming from the Prusa manual pages: https://manual.prusa3d.com