Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Grégoire Saunier

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preparation
[* black] Unload the filament present in your hotend.
[* black] Move the extruder all the way up.
[* black] Open the Rambo cover lid.
[* black] If at some point you are unsure about wiring check careful the Prusa manual pages.
-[* icon_note] The Rambo board images are coming from the Prusa manual pages: https://manual.prusa3d.com
+[* icon_caution] Disclaimer: As we are not Prusa nor Marlin we cannot guarantee that those information are 100% correct. They have to be taken as a base and any doubt or issue should be reported to us or to your printer manufacturer. We cannot be taken for responsible in case of something is going wrong following this guide.
+[* icon_note] The Rambo board images in this guide are coming from the Prusa manual pages: https://manual.prusa3d.com