Changes to Step #2
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Preparation | |
| [* 1] Unload the filament present in your hotend. | |
| [* 1] Move the extruder all the way up. | |
| [* 1] Open the Rambo cover lid. | |
| [* 1] If at some point you are unsure about wiring check careful the Prusa manual pages. | |
| - | [* 9] Disclaimer: As we are not Prusa nor Marlin we cannot guarantee that those information are 100% correct. They have to be taken as a base and any doubt or issue should be reported to us or to your printer manufacturer. We cannot be taken for responsible in case of something is going wrong following this guide. |
| [* 10] The Rambo board images in this guide are coming from the Prusa manual pages: https://manual.prusa3d.com |