Changes to Step #2

Edit by 3D_Gussner —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preparation
-[* 1] Unload the filament present in your hotend.
-[* 1] Move the extruder higher than the Rambo Cover.
-[* 1] Open the Rambo cover lid.
+[* 1] Unload the filament from your hotend.
+[* 1] Move the extruder higher than the controller cover.
+[* 1] ++Open the controller cover lid.++
[* 1] If at some point you are unsure about wiring check careful the Prusa manual pages.
-[* 10] The Rambo board images in this guide are coming from the Prusa manual pages: https://manual.prusa3d.com
+[* 10] The controller board images in this guide are coming from the Prusa manual pages: https://manual.prusa3d.com