Changes to Step #2
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Preparation | |
| [* black] Unload the filament from your hotend. | |
| [* black] Move the extruder higher than the controller cover. | |
| - | [* black] |
| + | [* black] Open the controller cover lid. |
| [* black] If at some point you are unsure about wiring check careful the Prusa manual pages. | |
| [* icon_note] The controller board images in this guide are coming from the Prusa manual pages: https://manual.prusa3d.com |