Changes to Step #7
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 8] Insert three M3 hex nuts |
|---|---|
| + | [* 5] Secure the top of the nozzle fan with an M3x25 screw and the printed par ''nozzle_fan_spacer'' |
| + | [* 6] Tighten an M3x8 screw |
| + | [* 4] Secure the ''nozzle_fan_duct'' with an M3x10 screw |
| + | [* 2] Finish to secure the nozzle fan with an M3x25 screw and a washer |
| + | [* 1] Connect the stepper cable. Pass nozzle fan and stepper cables into the little groove of the ''body_front'' |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added