Changes to Step #8

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Assemble Body Back
[* 4] Assemble ''body_back'' with two M3x8 screws. Make sure to not pinch any wire.
[* 5] Secure the ''body_back'' with two M3x40 screws
-[* 7] Connect the stepper cable and route them along the top groove with the nozzle fan wires.
-[* 8] Secure the cable cover with an M3x10 screw
+[* 7] Connect the stepper cable and route them in the top groove with the nozzle fan wires
+[* 8] Secure the cables with the ''cable_cover'' and an M3x10 screw
[* 9] Verify that no wire are pinched