Changes to Step #8
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Assemble |
|---|---|
| + | [title] Assemble extruder body back |
| [* 10] Stepper cable comes with a sleeve you need to remove. | |
| [* 4] Assemble ''body_back'' with two M3x8 screws. Make sure to not pinch any wire. | |
| [* 5] Secure the ''body_back'' with two M3x40 screws | |
| [* 7] Connect the stepper cable and route them in the top groove with the nozzle fan wires | |
| [* 8] Secure the cables with the ''cable_cover'' and an M3x10 screw | |
| [* 9] Verify that no wire are pinched |