Changes to Step #8

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Assemble extruder body back
-[* 10] Stepper cable comes with a sleeve you need to remove.
-[* 4] Assemble ''body_back'' with two M3x8 screws. Make sure to not pinch any wire.
+[* 10] Stepper cable comes with a sleeve you need to remove
+[* 4] Assemble ''body_back'' with two M3x8 screws. Make sure to not pinch any wires
[* 5] Secure the ''body_back'' with two M3x40 screws
[* 7] Connect the stepper cable and route them in the top groove with the nozzle fan wires
[* 8] Secure the cables with the ''cable_cover'' and an M3x10 screw
-[* 9] Verify that no wire are pinched
+[* 9] Verify that no wires are pinched