Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 4] Insert five M3 hex nuts in the back of the ''x_carriage'' |
|---|---|
| + | [* 7] Insert one M3 square nuts in the back of the ''x_carriage'' |
| + | [* 1] Route the stepper motor, nozzle fan and Pinda as shown in the second image |
| + | [* 3] Attach the ''x_carriage'' on the ''body_back'' with two M3x18 screws |
| + | [* 5] And one M3x10 screw |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added