Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Assemble X Carriage | |
| [* 4] Insert five M3 hex nuts in the back of the ''x_carriage'' | |
| [* 7] Insert a M3 square nut on the back of the ''pinda_mount'' | |
| [* 5] Install the ''pinda_mount'' on the ''body_back'' and secure it with an M3x10 screw | |
| - | [* 1] Route the stepper motor, nozzle fan and Pinda as shown in the second image. Make sure to not pinch any wires |
| [* 3] Attach the ''x_carriage'' on the ''body_back'' with two M3x18 screws | |
| [* 5] And one M3x10 screw | |
| [* 9] Double check you didn't pinch any wires. You should be able to slide them a little if you push/pull on them. |