Changes to Step #12

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Mount Hemera to Bear X axis
[* 5] Insert two M3 square nuts
-[* 1] Attach the Hemera on the Bear X axis (only the bearings are visible on this picture)
+[* 1] Attach the BearMera on the Bear X axis (only the bearings are visible on this picture)
[* 1] Make sure the nozzle fan, stepper motor, pinda and hotend fan cables are routed in between the smooth rods
[* 7] Close the top bearings using four M3x18 screws and the top of ''x_carriage_back''.
[* 9] Do not over tighten the four M3x18 screws.