Changes to Step #12
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] Assemble BearMera on X axis |
| [* 5] Insert two M3 square nuts | |
| [* 1] Attach the BearMera on the Bear X axis (only the bearings are visible on this picture) | |
| [* 1] Make sure the nozzle fan, stepper motor, pinda and hotend fan cables are routed in between the smooth rods | |
| [* 7] Close the top bearings using four M3x18 screws and the top of ''x_carriage_back''. | |
| [* 9] Do not over tighten the four M3x18 screws. |