Changes to Step #13
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Mount |
|---|---|
| + | [title] Mount Hemera to Bear X axis |
| [* 7] Route the belt | |
| [* 1] Add the bottom of ''x_carriage_back'' as shown in the second image. Make sure to not pinch any wire. You should not have to force to close it | |
| [* 4] Secure the ''x_carriage_back'' with an M3x18 screw | |
| [* 5] And two M3x10 screws | |
| [* 9] Double check that no wire are pinched, this is very important! |