Changes to Step #13

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[title] Mount Hemera to Bear X axis
+[title] Assemble BearMera on X axis
[* 7] Route the belt
[* 1] Add the bottom of ''x_carriage_back'' as shown in the second image. Make sure to not pinch any wire. You should not have to force to close it
[* 4] Secure the ''x_carriage_back'' with an M3x18 screw
[* 5] And two M3x10 screws
[* 9] Double check that no wire are pinched, this is very important!