Changes to Step #13

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Assemble BearMera on X axis
[* 7] Route the belt
-[* 1] Add the bottom of ''x_carriage_back'' as shown in the second image. Make sure to not pinch any wire. You should not have to force to close it
+[* 1] Add the bottom of ''x_carriage_back'' as shown in the second image. Make sure to not pinch any wires. You should not have to use any force to close it
[* 4] Secure the ''x_carriage_back'' with an M3x18 screw
[* 5] And two M3x10 screws
-[* 9] Double check that no wire are pinched, this is very important!
+[* 9] Double check that no wires are pinched, this is very important!