Changes to Step #13
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Assemble BearMera on X axis | |
| [* 7] Route the belt | |
| + | [* 10] If you have difficulties to pass the belt around the idler you can tape the belt end with the end of a zip tie. Then, feed the zip tie into the idler. |
| [* 1] Add the bottom of ''x_carriage_back'' as shown in the second image. Make sure to not pinch any wires. You should not have to use any force to close it | |
| [* 4] Secure the ''x_carriage_back'' with an M3x18 screw | |
| [* 5] And two M3x10 screws | |
| [* 9] Double check that no wires are pinched, this is very important! |