Changes to Step #13

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Assemble BearMera on X axis
[* 7] Route the belt
-[* 10] If you have difficulties to pass the belt around the idler you can tape the belt end with the end of a zip tie. Then, feed the zip tie into the idler.
+ [* 10] If you have trouble inserting the belt, it might be due to an extrusion multiplier issue (over-extrusion) or due to the use of a non-genuine or non-2GT belt. Check the [guide|27|step 5 of Preflight check and disassembly|stepid=664] chapter for more details.
[* 1] Add the bottom of ''x_carriage_back'' as shown in the second image. Make sure to not pinch any wires. You should not have to use any force to close it
[* 4] Secure the ''x_carriage_back'' with an M3x18 screw
[* 5] And two M3x10 screws
[* 9] Double check that no wires are pinched, this is very important!